02-23-2012, 02:57 AM
Hi to all
I have scania vci2 with sentinel dongel, and my sdp3 version was 2.6...
It has been worked properly, and I have been make diagnostic and programming and adjustig o...
After I installed new version such as SDP3 2.8 and this SDP3 ( 2.9 ) with blach update, I can not make programming or adjusting, I can only read and delete fault codes and check...
Help me please....
regards
I have scania vci2 with sentinel dongel, and my sdp3 version was 2.6...
It has been worked properly, and I have been make diagnostic and programming and adjustig o...
After I installed new version such as SDP3 2.8 and this SDP3 ( 2.9 ) with blach update, I can not make programming or adjusting, I can only read and delete fault codes and check...
Help me please....
regards