11-13-2011, 02:24 AM
Hi, I have just joined you all know.
I have been reading your Treads on this Forum & must say its very helpful
And your Honest opinions on this Forum!!!!!
Keep up the good work Guys.
This is my first tread and i need your advice if any experts can help
me out.
I have bought a LEXIA 3 with Diagbox 6.01 , Which i have installed it successfully,
But here my problem starts !!!!! The little instructions was with it only mentioned till here : Customer : scary01 ,
Activation no: 12345678901234567890123456789012 ,
Profile : 02ffffff .
and says click Green tick to complete the installation, enjoy!!!
And then it says: DO NOT REMOVE THE INTERFACE DURING THE UP DATE.
BUT I DONT EVEN KNOW WHEN I HAD TO CONNECT THE iNTERFACE And it wont even update OFFLINE.
Where have i being going wrong or can i even uninstall it and restart fresh? Please give me proper instruction , As with seller he is not answering my emails.
Looking Forward to Hearing from You?:
Many Thanks
Hanif
(The Reds)
I have been reading your Treads on this Forum & must say its very helpful
And your Honest opinions on this Forum!!!!!
Keep up the good work Guys.
This is my first tread and i need your advice if any experts can help
me out.
I have bought a LEXIA 3 with Diagbox 6.01 , Which i have installed it successfully,
But here my problem starts !!!!! The little instructions was with it only mentioned till here : Customer : scary01 ,
Activation no: 12345678901234567890123456789012 ,
Profile : 02ffffff .
and says click Green tick to complete the installation, enjoy!!!
And then it says: DO NOT REMOVE THE INTERFACE DURING THE UP DATE.
BUT I DONT EVEN KNOW WHEN I HAD TO CONNECT THE iNTERFACE And it wont even update OFFLINE.
Where have i being going wrong or can i even uninstall it and restart fresh? Please give me proper instruction , As with seller he is not answering my emails.
Looking Forward to Hearing from You?:
Many Thanks
Hanif
(The Reds)